Topic by stamkorg

  • Avatar
  • stamkorg
  • Member
  • Offline
  • Registered: 05-04-2014
  • Posts: 462

Topic: How to permanently activate "Parameters freeze"?

Hi,
Everytime I close Pianoteq, the Freeze function is disabled.
I would like to have this function always active.
Is it possible?

Thanks,
SK

Last edited by stamkorg (17-01-2024 21:26)

Reply by snurrfint

  • Avatar
  • snurrfint
  • Member
  • Offline
  • Registered: 18-01-2024
  • Posts: 47

Re: How to permanently activate "Parameters freeze"?

stamkorg wrote:

Hi,
Everytime I close Pianoteq, the Freeze function is disabled.
I would like to have this function always active.
Is it possible?

Thanks,
SK

I also want this. Who would not want to save the velocity response and volume between different presents every time? Nobody. So it should be kept on once you have enabled it the first time until you turn it off.

Last edited by snurrfint (19-01-2024 11:44)

Reply by Gilles

  • Avatar
  • Gilles
  • Member
  • Offline
  • From: Québec, QC
  • Registered: 18-07-2008
  • Posts: 3,344

Re: How to permanently activate "Parameters freeze"?

For "freezing" a global velocity curve, there is an option available when clicking the "G" button at the bottom right of the velocity curve graph. It's not very visible when off though...

If I remember well, the idea of keeping the global freeze at startup was deemed dangerous for accidentally modifying presets. An alternative, if you want to keep a set of parameters that you would like frozen, is the copy/paste feature. The panel is kept as defined between sessions and you use the paste feature to voluntarily change presets as needed.

Reply by Pinipon

  • Avatar
  • Pinipon
  • Member
  • Offline
  • Registered: 20-05-2010
  • Posts: 10

Re: How to permanently activate "Parameters freeze"?

I'm also interesting to have parameters freeze(d) by default at startup, because I'm using PTQ on touch device and would want maintain Diapason and Instrument condition the same for every instruments. Copy/paste solution is not convenient...
Is it possible to activate/enable "freeze" by default at startup, by tweaking some config file ?
Note: I'm using Linux arm64 version
Thank you in advance.

Reply by nahnou

  • Avatar
  • nahnou
  • Member
  • Offline
  • Registered: 28-05-2024
  • Posts: 6

Re: How to permanently activate "Parameters freeze"?

Hi,
Set the custom parameters per your liking. Then open the freeze panel by clicking the 'snowflake' button. Then click on the '...' button (below 'Favourites') and select 'Save'. Then click on the '...' button again and select 'Set as default'. Your custom parameters will then be applied on all presets and will be recalled when you open Pianoteq next time

Reply by Pinipon

  • Avatar
  • Pinipon
  • Member
  • Offline
  • Registered: 20-05-2010
  • Posts: 10

Re: How to permanently activate "Parameters freeze"?

nahnou wrote:

Hi,
Set the custom parameters per your liking. Then open the freeze panel by clicking the 'snowflake' button. Then click on the '...' button (below 'Favourites') and select 'Save'. Then click on the '...' button again and select 'Set as default'. Your custom parameters will then be applied on all presets and will be recalled when you open Pianoteq next time

Thank you very much!