Topic by stamkorg

  • Avatar
  • stamkorg
  • Member
  • Offline
  • Registered: 05-04-2014
  • Posts: 452

Topic: How to permanently activate "Parameters freeze"?

Hi,
Everytime I close Pianoteq, the Freeze function is disabled.
I would like to have this function always active.
Is it possible?

Thanks,
SK

Last edited by stamkorg (17-01-2024 21:26)

Reply by snurrfint

  • Avatar
  • snurrfint
  • Member
  • Offline
  • Registered: 18-01-2024
  • Posts: 22

Re: How to permanently activate "Parameters freeze"?

stamkorg wrote:

Hi,
Everytime I close Pianoteq, the Freeze function is disabled.
I would like to have this function always active.
Is it possible?

Thanks,
SK

I also want this. Who would not want to save the velocity response and volume between different presents every time? Nobody. So it should be kept on once you have enabled it the first time until you turn it off.

Last edited by snurrfint (19-01-2024 11:44)

Reply by Gilles

  • Avatar
  • Gilles
  • Member
  • Offline
  • From: Québec, QC
  • Registered: 18-07-2008
  • Posts: 3,342

Re: How to permanently activate "Parameters freeze"?

For "freezing" a global velocity curve, there is an option available when clicking the "G" button at the bottom right of the velocity curve graph. It's not very visible when off though...

If I remember well, the idea of keeping the global freeze at startup was deemed dangerous for accidentally modifying presets. An alternative, if you want to keep a set of parameters that you would like frozen, is the copy/paste feature. The panel is kept as defined between sessions and you use the paste feature to voluntarily change presets as needed.