Topic: The impedance slider ?
The greater the impedance, the longer the sound becomes. Where can I find this Impedance in Ptq 9?
Best wishes,
Stig
- Pianoteqenthusiast
- Member
- Offline
- levinite
- Member
- Offline
Re: The impedance slider ?
I think its length of the graph in the design section. The decay is the graph height and the high frequency cutoff is the point where the slope falls off.
Edit:
Duh, that can't be right its only 2 dimensions! The height is the impedance, and the high frequency cutoff is approximately where the slope starts to fall off. Still, this is what is used to vary the impedance.
Last edited by levinite (19-10-2025 03:08)
- Philippe Guillaume
- Admin
- Offline
Re: The impedance slider ?
levinite wrote:
The height is the impedance, and the high frequency cutoff is approximately where the slope starts to fall off. Still, this is what is used to vary the impedance.
I confirm
- Pianoteqenthusiast
- Member
- Offline
Re: The impedance slider ?
Thank you so much levinite and Philippe.
Best wishes,
Stig