Topic by Beemer

  • Avatar
  • Beemer
  • Member
  • Offline
  • From: Scotland
  • Registered: 24-09-2013
  • Posts: 185

Topic: Freezing velocity

Some time ago I posted a question asking how to permanently freeze my velocity curve.   I was confused then and still am because I just cannot make my calibrated curve stick permanently.

After a calibration I ctrl-f freeze the velocity select "default" then save it with a name.

I now expect my calibration to be present no matter which instrument I choose.   However when I select one I see that the velocity curve is a straight line.

What am I doing wrong?

I'm using Standard 5.3

Ian

Reply by EvilDragon

  • Avatar
  • EvilDragon
  • Member
  • Offline
  • From: Croatia
  • Registered: 27-06-2008
  • Posts: 3,960

Re: Freezing velocity

You don't need to save a preset... just freezing the Velocity checkbox in the Freeze panel should work with whatever velocity curve is in there. It works just fine over here.

Hard work and guts!

Reply by Gilles

  • Avatar
  • Gilles
  • Member
  • Offline
  • From: Québec, QC
  • Registered: 18-07-2008
  • Posts: 3,342

Re: Freezing velocity

Works here too. One thing you have to remember is to do it twice, once for each preset A and B if you want it permanent.

Last edited by Gilles (27-07-2015 19:45)

Reply by Beemer

  • Avatar
  • Beemer
  • Member
  • Offline
  • From: Scotland
  • Registered: 24-09-2013
  • Posts: 185

Re: Freezing velocity

Gilles wrote:

Works here too. One thing you have to remember is to do it twice, once for each preset A and B if you want it permanent.

Gilles,

Sorry for the delay in thanking you for your reply which solved my problem.

thanks,

Ian