Topic by rreuscher

  • Avatar
  • rreuscher
  • Member
  • Offline
  • Registered: 08-02-2013
  • Posts: 2

Topic: Pianoteq in Cubase 7.0 sustain controler issue

Hi,

I'm using Pianoteq in combination with my Roland Fantom G-8 and Yamaha FC-3 continious sustain controller. In my Fantom I can adjust the polarity of the Pedal. I put it to reverse, and everything works fine in the stand-alone version, and also within cubase when activate the direct monitoring in cubase.
But when I record a track, and play it back, then certainly the sustain pedal action seems to be inverted !!
Its very strange, because when I just play the piano via Cubase everything works great, but playing back the sustain pedal is inverted.
Checking the controler data in cubase looks just fine: pressing it, it goes up to 127, releasing: back to 0. But for some kind of strange reason, now pianoteq interprets the data in the inverted way during playback, while during live play, everything acts in the correct way....

Someone has this same experience ??

Best regards, Rene Reuscher

Reply by rreuscher

  • Avatar
  • rreuscher
  • Member
  • Offline
  • Registered: 08-02-2013
  • Posts: 2

Re: Pianoteq in Cubase 7.0 sustain controler issue

Hi All,

I fixed the issue. I took the Pedal apart and changed the polarity of the signal. I did not like anyway that the signal comming from the FC-3 was reversed. After changing the polarity ( by switching the 2 outer wires on the potentiometer ) everything works fine, in cubase and in the standalone version.

Best regards,

Rene Reuscher