Topic: The Ultimate Hybrid Digital Piano - Accurate acoustical reproduction
In effort to build the ultimate digital grand piano, similar-to/exceeding the Roland V Grand and Yamaha's Avant Grand, I would like to know how to creatively set up Pianoteq as an engine to drive a custom built digital hybrid piano.
THE BACKGROUND:
In and effort to recreate the sounds from my digital keyboard, I have come up short with many high end "point source" audio systems (conventional cone speakers). So I have dedicated the next few years to building my own "digital grand piano." I am in the process of integrating a Roland V Piano keyboard (I love the action) into a old (worn out) grand piano shell. The action, harp and strings have been removed, and the keyboard is close to being completed (stealth install, similar to http://www.youtube.com/watch?v=bJhPJaRRcns without the bling). I wish to install the audio reproduction element within the grand piano shell, as well as computer, amps, etc., for an all in one unit.
Falling short on finding speakers capable of reproducing a piano effectively (including setups in the Roland and Yamaha units mentioned above), I have opted to take advantage of my audiophile background and design my own reproduction system. I wish to model the audio reproduction system after an actual piano, and the Roland/Yamaha series units. I would like to reproduce the soundboard and strings separately. In order to do that, I have constructed 2 independent audio systems: 1) consists of 2 electrostatic speakers laid flat to imitate the strings of the piano. These are far superior to cone drivers for clarity, lack of high crossover points (and phasing problems) They are not "single point source," and their large surface area gives them the ability to reach required volume levels. 2) To reproduce the sound of the soundboard, I have a transducer array that has been mounted to either end of the bridge of the existing soundboard. I hope to attempt to reproduce part of a stereo image from both sources.
THE BIG QUESTIONS:
How do I utilize Pianoteq as a source for creating these different component models? I require 4 output channels (Stereo for strings and soundboard). Do I have to run 2 different computers to run 2 different Pianoteq programs with separate configurations to model each component (strings and soundboard)?
I am very aware that this is not the easiest way to do things, and know that I will not achieve the reproduction characteristics of an actual piano, but I hope to come "wowing-ly" close. I don't know if this is going to work, but I'm committed to the attempt!
Any input from the team at Pianoteq would be greatly appreciated. Maybe you have some insight into how you would go about this and/or how Yamaha / Roland &
others are processing information in their hybrid pianos.
Thank you in advance!
Robert