The new Thunder Pedal can result in really great sounds, and I'd like to create presets for this. Unfortunately there is no way to assign the pedal to be On by default, like there is for the Celeste pedal (which is set to the reversed state for the Felt presets). Please add a setting to reverse it also for the Thunder Pedal. Thanks!
Bumping this request.
Bumping this request.
As far as I know , you can invert any pedal by inverting the range in the midi option so instead of 0 , 1 enter 1, 0
Note : enabling the on by default is not equivalent to inverting the pedal .
Enabling the on by default semantically, means that the pedal is fully depressed at startup ( which can achieved scripting in a DAW) but the pedal keeps its normal behaviour .
Inverting the value , is a trick that sets the pedal on by default , but the behaviour of the pedal is different as inverted
Hope it helps
Thanks for the reply.
I tested the range inversion in the MIDI mappings, but this did not set the Thunder mode enabled by default.
The goal here is to have it enabled by default, immediately when you load the preset, without having to touch any pedals. Basically this would allow creating presets where the Thunder mode is expected to be _always on_, just like for the Felt presets the Celeste pedal is always on ("Reverse the celeste pedal" box is checked).