Topic by jimmi

  • Avatar
  • jimmi
  • Member
  • Offline
  • Registered: 20-12-2019
  • Posts: 31

Topic: Pianoteq 9 on Raspberry Pi5 goes segfault if started with VNC

I'm using Pianoteq 8 with a headless Raspberry Pi5 running Raspberry Pi OS. I use to start it with VNC and connect with my mobile or tablet.
This configuration is fine with PT8 but when I give a try with PT9 I read the following in VNC logs:

xstartup started
/home/pi/Pianoteq 9/arm-64bit/Pianoteq.sh: line 7:  1837 Segmentation fault      /home/pi/'Pianoteq 9'/arm-64bit/'Pianoteq 9' --fullscreen --multicore max
xstartup terminated

Started headless Pianoteq 9 runs fine.

Any suggestion how to debug it?

Last edited by jimmi (Today 08:19)

Reply by bazzo

  • Avatar
  • bazzo
  • Member
  • Offline
  • Registered: 13-09-2024
  • Posts: 11

Re: Pianoteq 9 on Raspberry Pi5 goes segfault if started with VNC

Hi Jimmi,

im not using Pianoteq via VNC but I have a similar issue when starting with the "--fullscreen" option. PT8 worked fine. Maybe try it without this option.

When PT9 is running windowed, it works. I can then switch to Fullscreen as long as the GUI is not in "Compact Mode".

Compact-Mode and Fullscreen-Mode both work exclusively, but when i try to combine them (both on at the same time) PT9 crashes instantly.

Regards Bazzo

Last edited by bazzo (Today 10:55)