Topic by leogardini

  • Avatar
  • leogardini
  • Member
  • Offline
  • Registered: 16-10-2014
  • Posts: 41

Topic: Automate harp pedaling

Hi there,

I've been trying and searching the entire morning but could not find anything in this regard.
I'm trying to automate the diatonic mode and harps pedal via midi CC, but it looks like there's no full-fledged solution for that at the moment.

I go to Options and Midi, set a CC to A/B switch (A = chromatic and B = diatonic). I can successfully make the switch work, but the problem is that whenever I touch the controller, it changes A to B and vice versa. I'm trying to make them toggle by setting vel. 0-64 to A and above to B.
Setting it to a low KS also gives the same problem.

How can I set up such midi behavior on Pianoteq 7?

I'm using the latest version, BTW.

Reply by leogardini

  • Avatar
  • leogardini
  • Member
  • Offline
  • Registered: 16-10-2014
  • Posts: 41

Re: Automate harp pedaling

No one?

Looks like no one has tried it yet.

Reply by Chopin87

  • Avatar
  • Chopin87
  • Member
  • Offline
  • Registered: 18-10-2012
  • Posts: 325

Re: Automate harp pedaling

Never tried before because I load just one of the two modes (either diatonic or chromatic) and notate for it in the DAW because they are not really interchangeable modes for scoring but I can see some advantages during live performances. I tried your setup and can confirm the random switching but I was unable to find a workaround.

"And live to be the show and gaze o' the time."  (William Shakespeare)