Bug: Pedal Curve only works for "Sustain" pedal setting

I have an analog sustain pedal. When the pedal is depressed all the way, Pianoteq seems to think it's at only 0.7.

I can use the "calibration" to adjust the max scaling, which is good.

But, then if I right click on the sustain pedal to make it something else (e.g. Pinch Harmonic) it doesn't seem to use the calibrated pedal curve; it still thinks it's only 0.7.

I tried going into the MIDI settings and adjusting the range. Since my max is 0.7, then I tried making the range from 0.0 to 1.43, since then my "0.7" would scale to "1.0." But, it doesn't let me set it higher than 1.00

Is there some way to do this? If not I would recommend letting us increase the max higher than 1.00.

Thanks