I've just been importing some of Qexl's suggested settings for Resonance eq (from the thread 'Pianoteq gets better and better') with the aim of setting them up as Equalizer presets. For some reason, it doesn't seem to work for me. It's OK if I save the whole thing as an fxp, but I was quite keen to have the eq settings ready to apply quickly to any preset. Has anybody else had problems like this?
At the moment, what is called Equalizer in the mini-preset menus only applies to the Eq3 effect it (should be renamed). The new global Equalizer settings can be saved (temporarily) to use in another preset only by freezing them. I guess another entry should be made in the mini-preset (now appropriately named Equalizer) since the settings are similar to velocity curves and not like the Eq3 parameters.
Yes, confirmed - the saved user's EQ preset after re-load ignoring (skip) user settings (curve points) for "Res Eq" and "Res Dur" sections. Only reloaded properly user curve for main EQ section.
(But problem is not reproduced in form of whole saved Pianoteq preset, as well reloaded DAW project which contain Pianoteq with user curves for specified sections - it's reloaded properly).
Minor bug.
These new resonance controls are great. It would be wonderful to be able to save and share presets for them.