2021-04-12T17:02:29Z PunBB https://forum.modartt.com/viewtopic.php?id=8353 i have the same pedal and suffer from the same inverted parameter problem.  even worse, i have to use a nonstandard controller for sustain.  what i do is run the midi files through a script i built using midicsv to convert them to something more standard for other people.

]]> https://forum.modartt.com/profile.php?id=5184 2021-04-12T17:02:29Z https://forum.modartt.com/viewtopic.php?pid=975253#p975253 I figured out a Hack/Fix for using a Yamaha FC3 sustain pedal through my non-Yamaha keyboard Expression controller input (a Nektar GXP 88 in this case).
The Nektar Footswitch input only works with On/Off switch-type pedals.
The Expression input works, but the Control Change info was reversed/inverted/upside down. Yes, I could set Pianoteq Controller 64 range to 1.00 and 0 which works for Pianoteq itself, but in my DAW all the info was reversed/inverted so if I sent the MIDI file to anyone else it would be wrong.
I opened up my pedal and reversed the red and black wires--unsoldered them and re-soldered them in the swapped positions, leaving the white wire in the center alone. Voila! I put my Nektar on the Exp type 2 setting to work with Yamaha pedals.
If you have questions, let me know. If I don't get notified by this site (I haven't posted anything before so I don't know how that works), you can email me at scott@scottwillispiano.com
I use the new version 7 NY Steinway D on my recordings, tweaked a little, mastered with multiband compression, an extra reverb, limiter, EQ to just cut any excess low frequencies, but pretty much stock.

]]> https://forum.modartt.com/profile.php?id=6865 2021-04-11T23:54:53Z https://forum.modartt.com/viewtopic.php?pid=975247#p975247