Modartt user forum - Pianoteq Standard: Timbre

Re: Pianoteq Standard: Timbre

2018-08-03T08:07:51Z

Actually, I think there's a way to change the timber in standard, but maybe it's not what you were looking for or what you were after.
You can do this by changing the hammer hardness, under voicing. When I mainly used the Bluethner, I wanted a slightly brighter sound, so I raised the hammer hardness for Piano, Mezzo, Forte by some small increments and the sound was brighter.
I'm not sure if this helps, but you could give it a try.

Re: Pianoteq Standard: Timbre

2018-07-31T08:32:24Z

Thank you.

Re: Pianoteq Standard: Timbre

2018-07-30T21:58:08Z

The direct sound duration, string length, strike point, along with the spectrum profile all affect the the timbre - (though that said, I've found I use different settings for these in different registers - only available in Pro)

Generally applicable:
Microphone positioning and the equalizer have a profound effect on timbre, if you'd like a darker/softer spirit per se.

Note that the equalizer (not the effects equalizer) works in pre-processing... from the manual:

"The fact that it works in pre-processing allows automatic volume compensation: for example, when increasing the medium spectrum, it will increase the medium frequencies in each note while keeping the natural balance across the keyboard. In other words, the middle notes will not get suddenly louder than the other ones. Another advantage of pre-processing is that it allows very fine variation in the EQ curve, unlike on a standard 3 band EQ. You can add (click) or remove (double click) control points and modify the curve by dragging them with the mouse."

....

Re: Pianoteq Standard: Timbre

2018-07-30T20:17:37Z

That's primarily a feature on sample based pianos (timbre shift). In Pianoteq, you can do stuff like this in much greater detail in Pro version, but not Standard, I don't think.

Pianoteq Standard: Timbre

2018-07-30T11:29:50Z

Hi,

How do you change the timbre (time stretch of the pitch/pitch shift while still C sounds as C) of a piano within P'teq STD? Would it be a feature in the future?