Modartt user forum - Pianoteq Play and Ableton

Re: Pianoteq Play and Ableton

2011-08-19T23:43:00Z

stevdo wrote:

Aha! You were completely right, Joe. Once I changed the input from 'all MIDI inputs' to just the one I was using, it worked fine. As I say, no other plug-in was affected, so I'm still a bit baffled, but thanks a million. That's made my day.

You are completely welcome. Glad to help!

Cheers,

Joe

Re: Pianoteq Play and Ableton

2011-08-19T17:30:47Z

Aha! You were completely right, Joe. Once I changed the input from 'all MIDI inputs' to just the one I was using, it worked fine. As I say, no other plug-in was affected, so I'm still a bit baffled, but thanks a million. That's made my day.

Re: Pianoteq Play and Ableton

2011-08-19T17:01:21Z

Thanks Joe, and I'll check but I'm pretty certain there's nothing like that, because no other plug-in is affected.

Re: Pianoteq Play and Ableton

2011-08-19T16:11:11Z

I have never used Ableton, but -- in general -- when notes become cut very short, there's a possibility of two conflicting midi note-on/note-off signals being sent simultaneously to the same midi channel.

Reading that the plug works fine for you in Reaper and as a standalone, is there anything in the Ableton setup that might be sending two simultaneous signals into the same channel? (i.e., midi feedback loop, or sending in omni mode perhaps?)

Joe

Pianoteq Play and Ableton

2011-08-19T14:50:06Z

Does anyone have any idea why notes played in the VST Pianoteq Play within Ableton Live might be irregularly (but very often) cutting very short, while the same plug works fine in Reaper, and the standalone version is fine?

I'm on Windows 7 BTW. Play works very well, incidentally, on the iMac (if only I could say the same for the iMac itself!)

Many thanks for any help.