Modartt user forum - Assign parameter to midi controller each time I open the program?

Re: Assign parameter to midi controller each time I open the program?

2024-02-19T19:46:40Z

NathanShirley wrote:

dtownpiano wrote:
Hello, everyone,
In reading the manual for Pianoteq 8, I've been able to successfully map certain values in the software to my Arturia Keylab 88 Mk II. Works fine, until I close the program and reopen it, at which time I have to do all that over again.
Is there a way to make these assignations and have them persist after the software is closed? (I'm working in standalone mode, but I suspect the same behavior would be present when using it as a plugin). Thank you kindly!
Options>MIDI>Global Midi Mapping>(save options here)

Thanks, Nathan! Got it!

Re: Assign parameter to midi controller each time I open the program?

2024-02-19T03:22:42Z

dtownpiano wrote:

Hello, everyone,
In reading the manual for Pianoteq 8, I've been able to successfully map certain values in the software to my Arturia Keylab 88 Mk II. Works fine, until I close the program and reopen it, at which time I have to do all that over again.
Is there a way to make these assignations and have them persist after the software is closed? (I'm working in standalone mode, but I suspect the same behavior would be present when using it as a plugin). Thank you kindly!

Options>MIDI>Global Midi Mapping>(save options here)

Assign parameter to midi controller each time I open the program?

2024-02-18T17:22:32Z

Hello, everyone,

In reading the manual for Pianoteq 8, I've been able to successfully map certain values in the software to my Arturia Keylab 88 Mk II. Works fine, until I close the program and reopen it, at which time I have to do all that over again.

Is there a way to make these assignations and have them persist after the software is closed? (I'm working in standalone mode, but I suspect the same behavior would be present when using it as a plugin). Thank you kindly!